Explore the winding technique

Let the computer automatically winding machine will get all kinds of coil winding and sound pretty smooth and beautiful, you need the appropriate input parameters Winder, hands-on experience of the Company's accumulated over the years, but also get a lot of know-how and skills on the winding, this collection organized into the following points, for your reference.
First, we must first feature is winding wire types, the number of the number of laps and appearance of the material, the winding speed have quite understand:
1. If the self-adhesive lines, enameled cotton, etc. To increase the diameter of the set a lot, because the skin too smooth, relatively non-inertial characteristics.
2. thread winding speed is not too slow, but it must start with a slow climb, so as not to pull off the wire.
3. The thick line, the speed should not be excessive (speed), but must pay attention to the adequacy of the low-speed torque.
Second, it was around the object (shape) is the level of the drain line and outgoing considerable distance relationship:
1. The square around the object speed is not too fast, in the middle there is a round convex irregularities affecting cable tidy.
2. The height of the device around the object and the cable should be appropriate, too easy to fall into one line, then there will be too high jumper phenomenon below.
3. The cable is wound with the outlet should not be too far away from the object, it will affect the accuracy of the cable follower.
The row is the tightness of the line outlet, also related to the winding and cable pretty or not.
Third, other matters:
1. Calibration is the width and start winding around the point of the matter as the first priority, and the most important.
2. When Kai around the point of accuracy, start winding, the width of parking is available at both ends of the test first, the set is correct.
3. When you start winding, whether beautiful or not, can provide a lot of information for your reference:
before a. Kai around too much or too points behind (at the outlet to be around no matter vertical phenomenon).
b. the cable is too sparse or too dense (diameter is not set correctly).
c. both ends of the swing is too fast or too slow
   (Width setting is incorrect: width = fast enough, too slow = width).
d. cable follower whether faster or more slowly
   (Re-tuning the diameter size: sooner = piecemeal, slower = big change).
e. Note that after the wrap wire layers coupled with the situation.
f. is wound around the object because after multiple layers variants.
g. diameter enameled marked size of the actual diameter, it must be added when setting the diameter of the thickness of the enamel will be correct.
h. After the completion of the winding, cable device reset (displacement) or not also affected.
i. sparse around the cable, start the best around point forward, narrowing the width of the best point.
j. tabbing automatic winding machine, can usually be overcome in the setting mode.