Automatic winding machine operation Simple Guide

1. Make sure that the electrical and compressed air in place, after manual reset state to start.
2. Automatic working condition skeleton staff of the body shall be placed on a feeding trough and tooling in the middle of the area, otherwise dangerous pinch will occur.
3. Confirm the path line porcelain eyes, anti-jumper through the situation before turning the tension the flywheel must be over the line in a circle. Open the folder manually uninstall line can easily switch must be turned off before turning it otherwise would not clamp securely.
4.The skeleton must put in place to ensure that, as happened on the skeleton is not in place to produce material damage, press the pause button, replace and make sure that all the skeleton in place before pressing the start button. The need to correct the skew pin skeleton, missing feet shall be placed.
5. In the event of a power outage or emergency stop accidental restart again after reset the clamp.
6. Check the disconnection range:
The path is smooth lines
Whether the normal tension
Skeleton is complete
Guide pin level is appropriate
Whether the line has run out of the barrel
7. Line connection: Before using online soon after completion of the new line and the old line knotted, hand pulled the guide pin and then start.
8. tension adjustment principle is set lower bound feet, when winding high, so as not to break the subsequent soldering. Can be adjusted according to the actual situation.
9. reservation button after very skilled in the use of automatic button must ensure that each cycle has sufficient time and complete skeleton placed grasp. This is recommended not to use two buttons.
10. When your hand on the touch-line-for-line if a foreign body glitches along the barrel, it will interfere with the line before the line, causing breakage.